Omron Healthcare HBF-514 - Manual (Page 21)

21
SETTING PERSONAL DATA
To measure Body Composition, your personal data must be set. Your personal data includes your age,
gender and height. The Full Body Sensor Body Composition Monitor
and Scale provides two options to
enter your personal data.
1) Select a personal profile number to save your personal data. The monitor saves up to 4 personal
profiles. Select a number 1 through 4. Use this number to enter your personal data when taking a
measurement.
2) Select UP/GUEST button if you do not want your personal data stored in the memory. When you
use the Guest mode you will need to enter your personal data each time you take a measurement.
Measurement results are not stored in the memory when the Guest mode is used.
1. Press the Power Switch to turn the monitor ON.
The CAL symbol blinks on the display, then the display
changes to 0.0 lb.
Wait until 0.0 lb appears on the display.
2. Lift the Display Unit out of the Display Unit Holder.
NOTE: This monitor can be set to either the US or Metric
System. Personal Profile and memory will be displayed
by selected system. To change the US/Metric mode:
1) Press and hold the DOWN/MEMORY button until “lb”
and “kg” blink on the display.
2) Press the DOWN/MEMORY button to select the mode, “lb” or “kg”.
This will automatically change “cm” and “feet/inch” under height setting.
3) Press the SET button to confirm the change.
Buttons Used in this Procedure
DOWN/MEMORY Button
Press this button to go back one.
Press continuously to rapidly
decrease.
UP/GUEST Button
Press this button to advance one.
Press continuously to rapidly
advance.
SET Button
Use this button to confirm the
personal data and move to the next
item after confirming the set item.
Personal Profile Number Button Personal Profile Number Button