Omega Vehicle Security LVR300 - Manual (Page 5)

All specifications are subject to change without notice.
LVR300 Series Quick Reference – Programming Steps
+ 0.0
Inch (cm)
S1
+25.5
S1
S1
S1
S1
S1
S1
+18.6
+18.6
+28.6
+21.6
+25.6
+25.
S1
Min.
Cursor flashing
2x
3x
9x
HOW TO MODIFY THE SENSOR
OPERATING PARAMETERS
Example: S1 = +18.6 Inches (or cm)
HOW TO ENTER ADDITIONAL
PARAMETERS & INFORMATION
+ 0.0
Inch (cm)
Code
0 0 1
Code
Code
Filter
Units
4 mA
0
Inch (cm)
1
0 1 1
0 1 1
Output
4-20 mA
20 mA
80
Turning left
moves the cursor
to the next deci-
mal position.
By turning the ring
to the left toward
Position 1,
the cursor disap-
pears and enters
the code. The
next parameter
arrives automati-
cally.
Code
0 0 0
Code
0 0 1
Code
1 1 1
T O R ETURN TO THE F ACTORY D EFAULT S ETTING :
Set the code to 989.
All individual parameters are now overwritten.
Start of analog
output range
(in the selected unit).
Set analog output
4-20 mA or 0-20 mA.
Selection of various
units (inches, cm, PSI).
Display and switch
points are recalculated
automatically.
End of analog
output range
(in the selected unit).
Filter for display and
analog output. (It is a
FIFO filter and the
time to accomplish the
actual measurement
value corresponds to
the seconds shown in
the display.)
In regular display
mode again.
Turning right
effects an increase
of the figure.
If the ring is turned
right toward Position 2
(EDIT), a cursor
appears while the
parameter you want to
modify is displayed.
Turn the ring 2 times to
the left, toward
Position 1, and the cur-
sor disappears. The
modified S1 is now vis-
able and the next para-
meter is shown
automatically.
Move ring 3 times to
the right, alternating to
Position 2 and center,
and you will see a
3-digit increase to the
figure marked by the
cursor’s location.
Turning left moves the
cursor to the next deci-
mal position.
Turning right effects
a change to the next
higher figure.
When the program
ring is turned to
the right toward
Position 2 (EDIT),
a cursor appears
at the parameter
to modify.
NOTE: If you remain idle in the programming stage
for 30 seconds, the display indication will return to
“measurement display” without saving your new set-
tings. You will have to cycle through the program
again to make your changes.