Omega Speaker Systems PH-2720-PA - Manual (Page 4)

3. Recommended Position
4. Installation
1
Preamplifier
2
Fitting
inlet
Hand
tighten
only!
In-line Applications
Preamplifier
1 2
Customer
supplied
pipe
3/4 in. NPT or
ISO 7/1-Rc 3/4
Submersible Applications
Sealant
PH-31542-TC Sensor Cap
(purchased separately)
A. O-ring lubricant
recommended
(factory applied) A. O-ring lubricant
recommended
(factory applied)
Sealant
B. Align
marks B. Align
marks C. C.
Fill with
3 to 4 in.
of sealant
3
• Vertical (0 ° ) position optimum
• 4 fps or less for max. performance and sensor life
0 °
Process
pipe
+60
°
Customer supplied:
• 3/4 in. NPT threaded
pipe (A)
• J-box (B)
• Flex conduit (C)
• Quick release pipe
clamp (D)
• Tank flange (E)
A.
B.
C.
C.
E.
B.
A.
D.
Closed
tanks
Open
tanks
In-Line
Caution: If liquid level is not constant, always ensure
liquid contact with electrode tip
Customer supplied:
• 3/4 in. NPT nipple (male)
• J-box
• flex conduit
-60
°
3/4 in. NPT OR
ISO 7/1-Rc 3/4
female threads
2 in.
min.
Attach 3/4 in. watertight pipe to the top of the preamplifier. Secure
the threaded connection to prevent any leakage. For additional
defense against possible accumulation of condensation at the back
seal area of the sensor, fill the lower 3-4 inches (75-100 mm) of
conduit or extension pipe with a flexible sealant such as silicone.