OWI AMP1SGB - Manual (Page 3)

Filename: AMP1SGB MANUAL
05/13/08
Page 3 of 4
Trouble Shooting Guide
1. No output: Check for loose screws on the green input connector. It is easy to think the wires are secure in the
connector and one wire is not. Tug on each wire to make sure each is tight.
2. Intermittent output: Check each input wire for loose screws.
3. Distortion: Do not power more than one AMP1SGB on one power supply. While it will work, it will cause
distortion.
LIMITED WARRANTY
1. The AMP1SGB product has been thoroughly tested and inspected at the factory. It is warranted for one (1)
year from date of purchase.
IT IS THE OWNERS’ RESPONSIBILITY TO ESTABLISH THE DATE OF PURCHASE BY
ACCEPTABLE EVIDENCE AT TIME SERVICE IS SOUGHT.
2. Any unit, which in the judgment of OWI INC. is defective or develops defects under normal use will be
replaced or repaired without cost within the warranty period.
3. This warranty will be considered void if unit has been dropped, misused, abused, altered in any manner,
overdriven with excessive amplification exceeding manufacturer’s specification, improperly serviced or
accidental damage.
4. OWI Inc. shall have no liability whatsoever for consequential damage. The sole responsibility and discretion
of OWI Inc. under this warranty shall be limited to the repair of the product or replacement thereof.
5. IMPORTANT: This warranty is void unless the attached card is completed and mailed to OWI Inc. within 10
days following the date of purchase. Units must be sent to OWI Inc. or to the dealer where purchased.