Sylvania SDVD7027 - Manual (Page 6)

8
Playing disc of DVD, MPEG4, SVCD, VCD, CD, MP3, Xvid
1. After connecting power to the unit, turn on the unit by sliding the ON/OFF
switch to ON,
2. Open the disc door and insert a disc into the door with the label side facing
up.
3. Close the disc door. The unit will load the disc and start playing.
4. Press to once to stop playback; then press to resume playback from
the point where you stoped; press twice to stop playback completely.
5. During playback, press to pause; press it again to resume playback.
6. When the playing is finished, please turn off the power by sliding ON/OFF
switch to OFF.
7. For some DVD disc with Title or Chapter menu, press “ MENU” button to
enter menu page, and use to select. Press ENTER to confirm.
the source menu will be displayed on the screen:
Basic Operation
Press to enter DVD mode or Media mode and press OK button to confirm.
When selecting “Media”, ensure to insert USB or SD/MMC card properly
play/pause
DVD MPEG4 SVCD VCD CD MP3 Xvid
DVD
MEDIA
Cursor button
ENTER
Title Menu
9
Note: Please do not disconnect USB devices or plug out SD/MMC cards
while they are working with the unit. Functional failure may occur in
case of wrong operations.
1
2
CR2025 CR2025
0
30
0
30
Please put the battery into the remote control as per below illustration
When using remote control, make sure the
infrared window is pointed to infrared receiving
window of the machine. The distance between
machine and remote control must be within 3
metres. Please refer to the following illustration.
Notice
1.To avoid falling off or place near damp environment.
2.To avoid infrared receiving window of the unit being under direct sunlight
3.Please use a new battery to replace old one if the remote control doesn't work.
The Use of Remote Control