Onkyo 7.2 Channel Network A/V Receiver TX-NR809 - Manual (Page 41)

41
En
You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
The following information can typically be displayed.
*1 If the input signal is analog, “Analog” is displayed. If the
input signal is PCM, the sampling frequency is displayed. If
the input signal is digital but not PCM, the signal format is
displayed. Information is displayed for about three seconds,
then the previously displayed information reappears.
When you connect an -capable Onkyo component, you
must configure the input display so that can work
properly.
This setting can be done only from the front panel.
The Whole House Mode is useful when you want to add
extra background music to your home party; this allows
you to enjoy the same stereo music as the main room in
separate rooms (Multi Zone: Powered Zone 2).
The Whole House Mode selects the same input source for
Multi Zone as the main room’s.
See also:
• “Speaker Setup” (
➔
page 47)
• “Multi Zone” (
➔
page 66)
Displaying Source Information
1 Press RECEIVER followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use the AV receiver’s DISPLAY.
Changing the Input Display
1 Press TV/CD, GAME or VCR/DVR.
“TV/CD”, “GAME” or “VCR/DVR” appears on the
display.
2 Press and hold down TV/CD, GAME or VCR/DVR
(about 3 seconds) to change the input display.
Repeat this step to select the desired input display.
Note
• DOCK can be selected for the TV/CD, GAME or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before using the
remote controller for the first time (
➔
page 73).
Input source
Input signal
resolution
Output
resolution
Signal format *1
Listening mode
Sampling
frequency
TV/CD
→
DOCK
→
→
TAPE
■
TV/CD:
GAME
↔ DOCK ■
GAME:
VCR/DVR
↔ DOCK ■
VCR/DVR:
Using the Whole House Mode
1 Press WHOLE HOUSE MODE on the front panel.
To cancel the Whole House Mode, change the input
source for the main room or select a listening mode
(
➔
page 34).
Note
• The Whole House Mode only supports analog audio.
• To use the Whole House Mode, Powered Zone 2 must be
set to enabled (
➔
page 47).
• Cancelling the Whole House Mode will switch Multi Zone
off.
• The sound from Powered Zone 2 may interrupt when
turning the Whole House Mode on or off.
• If you change the setting of Multi Zone while using the
Whole House Mode, this setting prevails over the Whole
House Mode’s.
• To adjust the volume of Multi Zone, switch the AV
receiver to Multi Zone control. See “Adjusting the Volume
for Zones” (
➔
page 68) for the volume adjustment of
Multi Zone.
• The Whole House Mode cannot be used while the “Audio
TV Out” setting is on.