Olympus C-40Zoom - Manual (Page 98)

98
Chapter 5
Sequential shooting (Cont.)
4 Take pictures.
● Press the shutter button all the way and
keep it pressed to shoot the preset
number of pictures. You can stop shooting
at any time by releasing the shutter button.
Auto bracket
Control panel
Modes & Drive mode
● In the following situations, sequential shooting (
, , BKT) is not
possible:
– When the record mode is set to TIFF (P. 105) or when the SHQ record
mode is set to ENLARGE SIZE (P. 109).
– When NOISE REDUCTION is set to ON (P. 117).
● During sequential shooting (
, , BKT), the flash does not fire.
● If there is not enough space available on the card for the number of frames
you have set during auto bracketing, you cannot continue shooting.
● If self-timer shooting is attempted when the still picture shooting mode ( ,
, , , , P, A/S/M, ) is set to sequential shooting, the
camera shoots 5 frames automatically.
● If the ISO is set to over 200, noise may appear under some shooting
conditions (P. 110).
● If the battery power is low and the battery check blinks during sequential
shooting, shooting stops and the camera starts saving the pictures you
have taken. Whether or not all of the shots are saved depends on how
much battery power remains.
● Since the shutter speed is set to 1/30 sec. max., exposure is decreased
when shooting a dark subject to prevent camera movement.
Mode Drive mode Factory default setting
,
All modes
A
All modes
S
M ,
,
All modes (BKT: Only in P/A/S)