Optimus 32-3009 - Manual (Page 13)

13
4. Stop playback of the selected in-
put source.
5. To preset the LINE 1 input source,
set PHONO 1 / LINE 1 to LINE 1.
Then repeat Steps 2–4.
Note: If you have to readjust MAS-
TER when performing Step 3, re-
member that this affects the level
of the previously preset input
sources. You must readjust those
sources until you get a reading of
up to
0 on the VU meters for each.
6. To preset the PHONO 2 input
source, set PHONO 2 / LINE 2 to
PHONO 2 .
7. Start playback of the selected in-
put source.
8. Slowly slide up the CH 2 volume
level slide control until you get a
reading of up to
0 on both VU
meters.
illustration of
PHONO 2/LINE 2 set
to PHONO 2
illustration of CH 2 control
Important: Write down or remem-
ber the
CH 2 volume level slide
control’s setting for the selected
audio source, so each time you
want to mix that source you can
slide the
CH 2 volume level slide
control to the correct setting.
Note: If it was necessary to set
the
CH 2 volume level slide control
all the way to 10 in order to get a
reading of up to 0 on the VU
meter, then slide CH 2 down to
about 8 and rotate MASTER clock-
wise until you get the reading of 0
on the VU meters.
9. Stop playback of the selected in-
put source.
10. To preset the LINE 2 input source,
set PHONO 2 / LINE 2 to LINE 2.
Then repeat Steps 7–9.
Note: If you have to readjust MAS-
TER when performing Step 8, re-
member that this affects the level
of the previously preset input
sources. You must readjust those
sources until you get a reading of
up to
0 on the VU meters for each.
11. To preset the LINE 3 input source,
set LINE 3 / LINE 4 to LINE 3 .
12. Start playback of the selected in-
put source.
illustration of
LINE 3/LINE 4 set to
LINE 3
32-3009.fm Page 13 Tuesday, August 10, 1999 8:31 AM