Oki B 4300 User Manual
Page 63
OPERATION > 63
4.
This specifies that the document should not be spooled, but
printed directly. Your application will not normally be ready for
further use until the print job is complete. This requires less
disk space on your computer, since there is no spool file.
5.
Directs the spooler to check the document setup and match it
to the printer setup before sending the document to print. If a
mismatch is detected, the document is held in the print queue
and does not print until the printer setup is changed and the
document restarted from the print queue. Mismatched
documents in the queue will not prevent correctly matched
documents from printing.
6.
Specifies that the spooler should favour documents which
have completed spooling when deciding which document to
print next, even if completed documents are lower priority
than documents which are still spooling. If no documents have
completed spooling, the spooler will favour larger spooling
documents over shorter ones. Use this option if you want to
maximise printer efficiency. When this option is disabled the
spooler chooses documents based only on their priority
settings.
7.
Specifies that the spooler should not delete documents after
they are completed. This allows documents to be re submitted
to the printer from the spooler instead of printing again from
the application program. If you use this option frequently it
will require large amounts of disk space on your computer.
8.
Specifies whether advanced features, such as pages per
sheet, are available, depending on your printer. For normal
printing keep this option enabled. If compatibility problems
occur you can disable the feature. However, these advanced
options may then not be available, even though the hardware
might support them.
9.
This button provides access to the same setup windows as
when printing from applications. Changes made via the
Windows Control Panel become the Windows default settings.
10.
You can design and specify a separator page that prints
between documents. This is particularly useful on a shared