One Stop Gardens CAR WASH NOZZLE 95996 - Manual (Page 3)

Page 3 SKU 95996 for technical questions, please call 1-800-444-3353.
operation instructions
With Car Wash Nozzle not connected to water supply, twist the Plastic Soap Con-
tainer counterclockwise and remove it from the Handle.
Fill with soap to highest level marked on the Plastic Soap Container. It is located
roughly 1/2” from the top of the Container.
Thread the Plastic Soap Container onto the Handle with clockwise motion, and
thread the Car Wash Nozzle onto your water hose at the Hose Connector located
at the base of the Handle.
Be sure the Mix-Water Dial is set at “Water” before turning on your water pres-
sure.
Select the pattern you wish to use by dialing the Pattern Adjustment Ring to any of
the 9 positions on the Ring.
Adjust the water pressure by turning the Water Pressure Dial towards Minus sign for
less pressure, or Plus sign for more water pressure. See
parts diagram on page
4 of this manual.
note: Always make sure you have released the Trigger and there is no pressure running
through the Car Wash Nozzle when you are changing spray patterns using the
Pattern Adjustment Ring. The same information applies to changing the position of
the Water-Mix Dial.
After making your Pattern selection and before squeezing the Trigger, change the
Water-Mix Dial to “Mix” (Soap). Now squeeze the Trigger and apply soapy water to
your vehicle.
To rinse, release the Trigger, change the Water-Mix Dial to “Water” and squeeze the
Trigger to get cold clean water for rinsing.
tips for getting a better wash
When possible, always wash vehicle in shaded area.
Thoroughly hose down the vehicle first with clean clear water.
Apply soap/water mix to entire vehicle from top to bottom. Use soft, lint-free towels
to wash wheels and hard to get areas. Wash entire vehicle lightly with soft towels
to completely loosen any dirt.
Rinse vehicle with cold, clean water.
Wipe vehicle down with soft lint-free towels or chamois cloths.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.