Oster BLSTET-C - Manual (Page 4)

6 7
m
akIng
F
rozen
d
rInks
NOTE: NEVER PUT ANYTHING BUT ICE IN THE ICE RESERVOIR.
1. Place the motor base on a clean dry flat surface with control panel
facing you.
2. With handle on the LEFT, place the Ice Shaver Main Body on top of
Motor Base and lock into position
by turning counter-clockwise (use
aligning arrows).
3. Install the Ice Reservoir to Ice Shaver
Main Body by first removing the Ice
Reservoir Lid (turning it clockwise to
the Unlock position). Then place the
Ice Reservoir on top of the unit and
lock into position by turning counter-
clockwise (use aligning arrows)
NOTE: In order to properly install the
Ice Reservoir to the unit, make sure to first
remove the Ice Reservoir Lid from the
Ice Reservoir.
4. Plug the unit into a standard 120 Volt wall socket.
For best results, use store-bought ice that has been out
of the freezer between 20-30 minutes.
5. Fill the Ice Reservoir with ice cubes.
6. Replace the Ice Reservoir Lid and rotate counterclockwise to the
locked position.
7. Remove Blending Jar Lid.
8. Add appropriate amount of liquid ingredients to the Blending Jar.
9. Replace Blending Jar Lid and position Blending Jar under the Ice Chute
by aligning the chute with the Blending Jar Lid.
10. Push the ON/OFF button to turn the unit on. Power Indicator Light will
blink slowly until the ice shaver or blender is placed on Motor Base.
t
he
B
est
m
argarIta
r
eCIPe (m
akes
3-4 d
rInks
)
Ingredients fl oz ml
Tequila 4 120
Triple Sec 3 90
Lime Juice 1-2 squirts
Margarita Mix 7 210
s
trawBerrY
d
aIquIrI
r
eCIPe (m
akes
3-4 d
rInks
)
Ingredients fl oz ml
Light Rum 4 120
Cranberry Juice 8 240
Sugar 3 Tbsp 45
Frozen Strawberries - sliced 1.5 cups 360
1
2
3
4
5
7
6
8
9
Control Panel
1. ON/OFF Button – Press this button to turn the
unit “On” or “Off”.
2. Power Indicator Light – Turns on and blinks
rapidly indicating unit has power.
3. Auto Shave/Auto Blend – Activates auto
shaving and blending cycles.
4. Status Indicator Lights
• Blue Lights – Pulse slowly to indicate which
button to press during auto cycle OR remain
illuminated during auto cycle.
• Red Lights – shows product safety interlocks
are not engaged.
5. Pulse Button
6. Stop Button
7. Low Button – Blender low speed
8. Med Button – Blender medium speed
9. High Button – Blender high speed