Omron Healthcare OMRON HEM670IT User Manual
Page 2
2
¾
Place the user selection switch to User A.
¾
Follow the instructions in the manual pages 23‐26 on applying the arm cuff
¾
Take a measurement with your blood pressure monitor
o
Press the Start/Stop button.
o
The arm cuff will start to inflate automatically taking a measurement.
o
When the measurement is complete, blood pressure and pulse rate are displayed.
Step 2: Get ready to use your blood pressure monitor with HealthVault
¾
If HealthVault Connection Center is not running on your computer, please start it and sign in to
your account. Connection Center then will open to a screen showing your device(s).
¾
Select the Omron Blood Pressure device picture on the left hand side of Connection Center.
¾
If you do not see a picture of your device in Connection Center, select Set up a new device and
follow the on‐screen instructions.
Step 3: Connect your Omron Blood Pressure Monitor to your computer
and upload your reading to HealthVault
¾
Press the Start/Stop button to turn the monitor off.
¾
Find the USB cable that came with your blood pressure monitor.
¾
Plug the small end of your USB cable into the slot on your blood pressure monitor that's marked
with the USB symbol.
¾
Plug the large end of your USB cable into your computer.
¾
The symbol “
□
” will start circling on the blood pressure monitor display when it is successfully
connected to the computer. After several seconds the blood pressure display will be blank.
NOTE: If the USB cable was connected when you took the last measurement, please disconnect and
connect the cable again. Also, do not unplug the USB connector until the data has finished uploading.
HealthVault Connection Center will sense when your device has been connected to your computer and
will prompt you to upload your test reading.
¾
Follow the on‐screen prompts.
You will see confirmation when your upload is complete. At that point you may unplug your blood
pressure monitor from your computer.
To see your reading in your HealthVault account:
¾
Open your Internet browser and go to
. (You will be asked to sign in if
you haven't accessed your account in the past 20 minutes.)
¾
Click your Health info tab.
Whenever you have taken new readings with your device, you can follow the steps outlined in “Step 3”
of this guide to upload the readings to HealthVault and better manage your health and fitness.