Onkyo TA-RW244/144 - Manual (Page 12)

12
Connecting ONKYO components for z op-
eration
For remote control operation
The upper and lower remote control jacks
have the same function.
For remote control operation, connect this
jack to any ONKYO amplifier, receiver or
CD player bearing the z symbol using the
remote control cable.
Note:
Do not attempt to connect the z remote
control jack to any equipment other than an
ONKYO component bearing the z
symbol. Doing so could cause the unit to
malfunction.
The function listed below can be accom-
plished using the remote control of the
master unit.
s a : Play
d : Rewind
f : Fast forward
e : Stop
t : Rec/Pause
CD synchro recording system
Once connections are made, as shown left,
this function becomes enabled. It automati-
cally starts recording on the cassette deck
when the s button of the CD player is
pressed. (See page 9.)
ONKYO
ONKYO
POWER
ON OFF
ON OFF
ONKYO
6 DISC
1 2 3 4 5 6 7 8 9 0 +10
ONKYO
Tuner
CD Player
Main amplifier
Pre amplifier
TA-RW244
TA-RW144
If this unit is properly connected to another ONKYO component bearing the z symbol, you will be able to control it using the other
component’s remote control.