All reset, Continuous firing, Continuous firing all reset – Olympus FL-50 User Manual
Page 15
Continuous firings make the light-emitting section hot and may cause it to deteriorate or malfunc-
tion. Therefore, continuous firing should be limited to the counts shown in the following table.
Always leave the electronic flash unused for at least 10 minutes after continuous firing up to the
limit count.
CONTINUOUS FIRING
ALL RESET
All Reset resets the custom setups to the factory default settings.
• Press the MODE and LIGHT buttons simultaneously for 2
or more seconds to reset the custom setups (except for
the distance display unit (m/ft)) to the default settings.
• The distance display unit (m/ft) is not altered by the all
reset operation.
Limit counts of continuous firings
•Available counts of flash emission in synchronism with continuous shooting
The following table shows the flash emission count that can be synchronized to successive
shooting of the camera. Note, however, that the electronic flash should be left unused for more
than 10 minutes once the maximum continuous flash emission count has been reached.
Number of frames that can be synchronized successively
(assuming that the continuous shooting rate of the camera is 8 frames/sec.)
Light intensity ratio
External power supply
1/4
1/8
1/16
1/32
1/64
1/128
None
Batteries in FL-50
Flash Power Grip FP-1
(C/R14 alkaline batteries/
C/R14 Ni-Cd batteries)
High Voltage Pack HV-1
(Ni-Mh battery pack BN-1)
AA (R6) alkaline batteries
AA (R6) lithium batteries
AA (R6) Ni-Mn batteries
AA (R6) Ni-Cd batteries
AA (R6) Ni-Mh batteries
CR-V3 lithium battery pack
AA (R6) alkaline batteries
AA (R6) lithium batteries
AA (R6) Ni-Mn batteries
AA (R6) Ni-Cd batteries
AA (R6) Ni-Mh batteries
CR-V3 lithium battery pack
None
AA (R6) alkaline batteries
AA (R6) lithium batteries
AA (R6) Ni-Mn batteries
AA (R6) Ni-Cd batteries
AA (R6) Ni-Mh batteries
CR-V3 lithium battery pack
None
2
5
10
16
30
40
frames frames frames frames frames frames
4
40
40
40
40
40
frames frames frames frames frames frames
4
20
40
40
40
40
frames frames frames frames frames frames
Flash control mode
Flash intensity
Flash interval
Limit count
TTL AUTO
AUTO
MANUAL
FP AUTO
FP MANUAL
FULL; 1/1
1 sec.
10
1/2
0.5 sec.
20
1/4
0.3 sec.
40
1/8 to a/128
0.2 sec. or less
80
2
5
12
40
40
40
frames frames frames frames frames frames
2
5
16
18
40
40
frames frames frames frames frames frames