Optimus 120-1995 - Manual (Page 10)

select A1 to store the first group of AM stations.
3. Tune to the station which appears on the band immediately before the
first station you want to store in memory.
4. Press and hold down AMS for 3 seconds. The system scans the selected
band and then stores the next six strong stations. The memory location
number and the station's frequency appear on the display for each
stored station.
When it finishes storing stations, the radio begins scanning all stored
stations. The channel number flashes and the radio tunes to each station
for 5 seconds.
Note: The radio scans once for storing stations, twice for weaker
stations and three times for weak stations. After that if all memory
locations are not full, it continues storing previously stored stations
until all locations are full.
Storing Stations Manually
1. Turn on the radio.
2. Press BAND to select the band and memory group. For example, select
A1 to store the first group of AM stations.
3. Use any tuning method to tune to the station you want to store into
memory.
4. Press and hold down the desired memory location number until the audio
momentarily mutes.
The memory location number and the station's frequency appear on the
display for each stored station.
Scanning Stored Stations
Press BAND to select the desired band and memory group. Press MS to scan
the stored stations in that group. The radio scans the stored stations,
pausing for 5 seconds at each station. When the radio pauses at a station
you want to listen to, press MS again.
Note: Do not hold down MS. This sets the radio to automatically store
stations into memory.