Onkyo BD-SP807 - Manual (Page 13)

13 EN
CONNECTIONS
Connection to the TV
• Make one of the following connections, depending on the capabilities of your existing device.
COMPONENT
VIDEO IN
Y
P B
P R
AUDIO IN
L R
VIDEO
IN
HDMI IN
and or or
* 1, 2
TV
this unit
standard audio
RCA audio cable
AUDIO CONNECTION AUDIO / VIDEO
CONNECTION
HDMI cable
best audio / picture
Method 3
VIDEO CONNECTION
RCA
video cable
Method 1
standard picture
RCA component
video cable
better picture
HDMI OUT VIDEO OUTPUT
(COMPONENT)
Method 2 *
1
(Green)
(Blue)
(Red)
(Blue) (Red) (Green)
VIDEO OUTPUT
(VIDEO)
AUDIO OUTPUT
(DOWN MIX L/R)
* 1) This unit is compatible with the progressive scan system. The feature provides you with the higher quality pictures
than traditional output system does. To utilize this feature, a component or an HDMI connection is required. Refer
to “HDMI Video Resolution” or “Component Output” setting on page 36 to set the video resolution.
* 2) Analog audio connection is not required for this connection.
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• Connect this unit directly to the TV. If the RCA audio / video cables are connected to a VCR, pictures may be
distorted due to the copy-protection system.
• If the picture is not output properly to the TV because of “HDMI Video Resolution” or “Component Output” setting,
press and hold [
B (play)] on the front panel for more than 5 seconds. “HDMI Video Resolution” and “Component
Output” setting will be reset to the default automatically. You cannot change the video resolution during Blu-ray
Disc playback. To change the resolution, stop playback.
• A simple 1-cable connection with a device having an HDMI (high-definition multimedia interface) jack allows
digital transfer of both digital video signals and multi-channel audio signals.