Orion Car Audio CO6002 - Manual (Page 6)

© 2008 directed electronics—all rights reserved 5
CEA SPECIFICATIONS
CO3002
Power Output: 60 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 80 Watts RMS x 2 at 2 ohm and < 1% THD+N
CO6002
Power Output: 100 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 155 Watts RMS x 2 at 2 ohm and < 1% THD+N
HIGH LEVEL HARNESSES
Do not connect the high level input connections to power, signal, or chassis ground as damage
to the head-unit outputs may result. The high-level inputs are designed to work with either
grounded or BTL speaker level outputs (found on most head units).
HIGH LEVEL CONNECTIONS
WIRE COLOR INPUT CONNECTION
Black Ground
White/Black - Left channel
White + Left channel
Gray/Black - Right channel
Gray + Right channel
AMPLIFIER SETTINGS
Signal Input and Output Configurations
The input section of the amplifier consists of a phase switch that sets the output configuration,
gain controls, and RCA inputs. The input section makes it easy to adapt this amplifier to most
system configurations.
Input Gain
The Orion Cobalt CO3002 and CO6002 amplifiers have level adjustments to allow for easy inte-
gration with any source unit. The input sensitivity can be adjusted from 175mV to 8V. Refer to
Testing the System and Adjusting the Sound of the System sections of this guide for detailed
instructions on setting the gain.