Omega Engineering OMG-PCI-DIO48 - Manual (Page 10)

Technical Description
OMG-PCI-DIO48 Page 6
Pull Ups
Ten pin bussed resistor packs are installed to provide pull-ups to the input ports. These are
installed on all ports. The pull-up resistor packs are rated at 10K ohms. Figure 2 below provides the
bussed resistor and corresponding port. The resistors insure that no line is floating which is not
connected. This provides consistent biasing on all un-terminated lines.
Bussed Corresponding Bussed Corresponding
Resistor Port Resistor Port
RP4 Port A1 RP1 Port A2
RP5 Port B1 RP2 Port B2
RP6 Port C1 RP3 Port C2
Figure 2-Pull Up Resistors