Oregon Scientific Action Cam ATC3K - Manual (Page 8)

11
c) Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Only batteries of the same or equivalent
type as recommended are to be used together.
Turning the Camera On
Press and hold the On/Off Button
for 2 seconds (two
beeping sounds). The LCD screen will show the
remaining time.
For your safety, do not press any buttons on the camera
during sports activities.
Turning the Camera Off
1. Press and hold the On/Off Button
for 2 seconds
(two beeping sounds). The LCD screen will turn off.
2. The camera will be turned off automatically after 30
minutes of not being used unless it is in USB mode.
Note: If the camera is connected to your PC, you have to unplug the USB
cable to turn the camera off.
Note: Ensure that the ATC3K is turned off during the insertion or the
removal of the SD card. The card and the data may be damaged if the SD
card is inserted or removed while the camera is on.
12
VII) Camera Usage
Battery Installation
Use Caution, the edge of the base clip may be sharp.
When unscrewing the cover make sure the clip is in
the same direction as the lens. Observe the following
precautions when unscrewing the cover of the camera:
1. Unscrew the cover at the end of the unit.
2. Place your finger on the 'lip', which is on the bottom
half of the rear of the unit, and pull in an upward
direction to open the battery slot door.
3. Insert 2 x AA alkaline batteries into the battery slot
with the polarity in the direction as shown.
4. Close the battery slot door and screw on the end of
unit cover.
Note: When the battery is low, the low battery icon will
appear on the LCD screen.
Always upload video footage to your PC prior to
replacing batteries to avoid memory loss
Note:
a) Do not mix old and new batteries together. Replace
both batteries at the same time.
b) Remove the batteries if the camera is not going to be
used for extended periods of time.