Odyssey Electronics Building Set - Manual (Page 17)

Y our locomotive is illuminated by four
lamps. One is located in the headlight
housing mounted on the boiler front. A lamp
illuminates the interior of the cab. Two red
lights (1 assembly) show through the ash
pan grating and shine brighter when the
speed of the locomotive increases. During the
course of normal operations, they may
require replacement.
Removing the three cab screws as show on
page 16 will allow access to the inside of the
cab and the expired lamps. But, due to the
close fit of many components and the inter-
connected wiring, we recommend that you
take your locomotive to your Authorized
Lionel Service Center for any required lamp
replacement.
Lamp Numbers:
Headlight (1)
620-8029-300
Cab light (1) 610-8082-019
Ash Pan (1 Assembly) 620-8063-300
Note: The green front marker lights are
LEDs (Light Emitting Diodes), and are not
user serviceable.
Note: Two red marker lights at the rear of
the tender are also LEDs and are not user
serviceable.
17
Servicing your locomotive’s lamps
Maintaining and servicing your locomotive
Before changing the lamps in your locomotive, be sure to check that the AUX2 com-
mand was not used to turn off the front headlight.
Note!