Oregon Scientific Camera ATC-1000 - Manual (Page 7)

Taking Photos
Once the ATC-1000 is turned on:
The frame number shown on the LCD display will
indicate how many shots are available for shooting.
1. Aim at the subject that you want to shoot.
2. Press the ‘Photo shutter button’ to take photos.
The remaining number of photos, shown on the
LCD display, will decrease by one each time.
(Sometimes it will decrease by two if the photo is
very densely colored.)
3. The frame number shown on LCD display indicates
how many shots are still available before the memo-
ry is full. The counter will automatically deduct one
after each shot is taken. It is displayed as a count-
down.
4. When a photograph is taken, a single short ‘beep’
will be heard. After the ‘beep’ sounds, the camera is
ready to take another photo.
Note:
1. Default resolution is 640 x 480
9
Taking Video Footage
1. Aim at the subject you want to shoot.
2. Press the ‘Movie shutter button’ to start
recording. The time elapsed will be shown on
the LCD display.
3. Press the ‘Movie shutter button’ again to stop
recording. The length of the movie clip will show
on the LCD display for 3 seconds, after which the
remaining time will show. (The remaining time is
only an estimate).
4. Press and hold the ‘Menu’ button for 2 seconds to
select the desired resolution (640 x 480,
320 x 240, 160 x 120). Press the ‘Menu’ button
again to cycle through the icons representing
these resolutions (at the top of the LCD display),
as described on page 12. The icons will flash until
you press ‘Enter’ to confirm your selection.
Note:
1. Default resolution is 640 x 480 (VGA).
2. When the time is shown, you will see‘H’for hour,
‘M’ for minute and ‘S’ for second.
10
HC18_manual_1_sep 9/2/05 16:50 Page 7