Oricom Secure 100 - Manual (Page 3)

1 WARNINGS AND SAFETY INFORMATION
IMPORTANT
Please read this user guide thoroughly before use.
Your ORICOM Baby Monitor is designed to be an aid and
should not be used as a substitute for responsible and
proper adult supervision of a child.
The Baby Monitor has been designed to provide some
added reassurance in the form of sound transmission
for those times when you are not in the same room as
your baby provided you always stay within hearing range
of the baby monitor during use. Your Baby Monitor is
not a medical device, nor a device to prevent cases of
Sudden Infant Death Syndrome (SID'S) or "cot death",
and you should not rely on it for your baby's wellbeing. It is
important that you regularly check on your baby personally.
Make sure the Baby unit, Parent unit and mains adaptor
cables are kept out of reach of your baby and other young
children within the house at all times, at least one metre
away from the baby's cot.
Never place the baby unit inside your baby's cot, bed or
playpen.
Never cover the Parent or baby units with clothes, towels
or blankets or any other item.
Do not place the cord in a high "wear and tear" location.
Never use a frayed or compromised cord.
Never use or place your Parent or Baby units in or near
moisture or water (e.g. near bath or pool). Immersing in
water can cause electric shock and even death.
Power requirements
In Australia this product requires an electrical supply of
220-240 volts, single phase/alternating current.
Use only the mains power adaptors supplied with this
equipment. Incorrect adaptor polarity or voltage can
seriously damage the unit and/or cause physical harm
and even death. The adaptors may become warm during
use, please take care when handling.
AC Adaptor (Baby unit)
AC Adaptor (Parent unit)
Input: 240V
AC
50Hz Input: 240V
AC
50Hz
Output: 6V
DC
200mA Output: 6V
DC
200mA
!
CAUTION
If you plan to use your Baby monitor whilst travelling
overseas, make sure that the voltage shown on the mains
power adaptor is the same as the local mains power before
connecting to the power supply. Do not use any voltage
converter with the monitor.