Onkyo TX-NR515 - Manual (Page 23)

Turning On & Basic Operations
En-23
Playback
■ Operating with the remote controller
■ Operating on the AV receiver
The on-screen menus appear only on a TV that is
connected to the
HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver’s display when changing settings.
This section describes the procedure for using the
remote controller, unless otherwise specified.
Playing the Connected Component
1 Press RECEIVER followed by an INPUT
SELECTOR button.
2 Start playback on the source component.
See also:
• “Playing an iPod/iPhone via USB” (
➔ page 25 )
• “Playing a USB Device” ( ➔ page 26 )
• “Listening to vTuner Internet Radio” ( ➔ page 27 )
• “Registering Other Internet Radio” ( ➔ page 28 )
• “Playing Music Files on a Server” ( ➔ page 29 )
• “Remote Playback” ( ➔ page 30 )
• “Listening to AM/FM Radio” ( ➔ page 31 )
• “iPod/iPhone Playback via Onkyo Dock”
( ➔ page 68 )
• “Controlling Other Components” ( ➔ page 70 )
3 To adjust the volume, use VOL / .
4 Select a listening mode and enjoy!
See also:
• “Using the Listening Modes” (
➔ page 37 )
RECEIVER
VOL /
INPUT SELECTOR
Listening mode buttons
1 Use the input selector buttons to select the input
source.
2 Start playback on the source component.
3 To adjust the volume, use the MASTER VOLUME
control.
4 Select a listening mode and enjoy!
■ Screen saver
If there is no video signal on the current input source and
no operation for a specific time (three minutes by
default), a screen saver automatically comes on.
Tip
• The time until the screen saver activates itself can be changed
in the “Screen Saver” setting ( ➔ page 61 ).
• The screen will return to its previous state if the AV receiver is
operated.
MASTER VOLUME LISTENING MODE
Input selector buttons