One for All SV-1716 - Manual (Page 5)

WWW.ONEFORALL.COM
5
Put both "RECEIVER" and "TRANSMITTER" on the same channel by using the slide switch on the back side of
the units
Connecting the TRANSMITTER unit
Make sure that the SCART is connected to the correct Output of the device, normally called “Line Out”.
If you wish to remotely control the source device (satellite receiver, video recorder, camcorder, DVD player,
digital or analogue Set-Top Box or Pay-TV decoder box) from another room, for example to change channels
on your satellite receiver, you will need to:
Connect the IR eye to the TRANSMITTER. Place the IR eye directly on the IR receiver window on the front-side
of the source device OR place the IR eye in front of the source device (make sure there is no interference
of the IR Eye signal going to the IR receiver of the source device).
Insert the adapter plug into the connector on the backside.
Now that the unit is connected you can switch ON the Unit using the ON/OFF key.
The red LED on the front should light up.
Connecting the RECEIVER unit
Make sure that the SCART is connected to the correct Input of the device, normally called “Line In”.
Insert the adapter plug into the connector on the backside.
If you want to control the source device, place the Remote Control Extender on top or beside the destination device
where it is able to catch the IR command from your remote control.
Now that the unit is connected you can switch ON the Unit using the ON/OFF key.
The red LED on the front should light up.
Installation See page 2
1
2
3
SV_1716_AV_Sender UK 15x17:SV_1715_AV_Sender 17 talen 05-11-2007 12:09 Pagina 5