Oregon Scientific JUMBO RF WALL CLOCK WITH NIGHT SENSOR NR868 - Manual (Page 6)

EN
5
STRONG
SIGNAL
WEAK SIGNAL
Clock:
NOTE The nightlight has a Power ON / OFF switch to
help conserve power. Use the AC adaptor when using
the nightlight for long periods of time. The batteries
are a good power source for back-up usage.
ABOUT RADIO RECEPTION
This clock can automatically synchronize the date
and time with official time-keeping organizations in
Frankfurt (Germany) and Rugby (England). The unit
can pick up an RF signal when it is within 1500km (932
miles) of these locations.
To select the most suitable radio signal for your
location, slide the EU / UK switch to the appropriate
setting. Press RESET whenever you change the
selected setting.
NOTE For best results, place the unit away from
metal or electrical objects, and near a window with a
clear view to the sky.
TURNING THE RADIO RECEPTION ON / OFF
To turn the radio reception on:
z
Press and hold the clock button for 2 seconds.
z
The RF reception icon will appear and flash on
the display to indicate it is searching for the RF
signal.
Once batteries have been installed in the clock, the
reception icon will flash to indicate it is searching for
a signal.
When the reception signal has been received the
reception icon will show the signal strength by
displaying between 0 and 3 waves:
Nightlight:
NO SIGNAL
To turn the radio reception off:
z
Press and hold the button for 2 seconds.
z
The RF reception icon will disappear from the
display.
NOTE Replace the batteries whenever the low battery
icon
is displayed. Change all the batteries at the
same time - it is dangerous to mix old and new batteries.
Protect your environment by taking exhausted batteries
to authorized disposal stations.
shows on the clock display when the batteries
are low.
The LED indicator on the motion sensor will flash in
red when the batteries are low.
AC ADAPTOR
The 4.5V AC adaptor connects to the nightlight as
shown below.