Oregon Scientific VR101 - Manual (Page 8)

EN
7
If the clock behaves strangely or stops responding, insert
and press a blunt stylus into the vibration device's Reset
Hole. (This is located inside the vibration device. Remove
the back of the vibration device just above the Alarm 1,
Alarm 2, All switch and above the battery compartment).
Simply insert a blunt stylus to reset the unit's settings.
TROUBLESHOOTING GUIDE
BASIC FUNCTIONS
This section includes a list of frequently asked questions
for problems you may encounter. If your device is not
operating as you think it should, check here before
arranging for servicing.
Problem: No alarm.
Symptom: Alarm does not vibrate.
Check this: Alarm is disabled.
Remedy: Turn on the alarm setting.
Problem: Operation is not normal.
Symptom: Certain functions do not perform.
Check this: Device requires reset.
Remedy: Reset the unit with a blunt stylus pressed
against the Reset Hole.
THE SNOOZE FUNCTION
While the alarm goes off, press the SNOOZE / LIGHT
button on the main unit to stop the Alarm and enable
the Snooze function.
When the Snooze function is enabled, the Snooze alarm
will last between 8 and 9 minutes. Also, the snooze
function will be disabled if 1) the clock time is changed;
2) or the alarm ON / OFF button is pressed.
When the Snooze function is enabled, the
Bell Icon will be flashing at 1Hz.
THE RESET HOLE
NOTE
VR101 English R8 OP 7/15/04, 10:05 AM 7