Sony DPP-MP1 - Manual (Page 17)

17 GB
Continued
Printing
To cancel the operation while
printing is in progress
If you have specified several prints but
want to cancel the operation before it is
completed, press the PRINT/STOP
button. The indication “WAIT” appears
on the display, and printing stops after
the current print is finished.
If unit runs out of paper or print
cartridge ribbon while printing
If the unit runs out of paper while
printing, the indication “PAPER”
flashes on the display. If the print
cartridge ribbon runs out, the indication
“RIBON” flashes on the display.
To continue the current operation, load
print paper or replace the print cartridge
without turning the unit off. Press the
PRINT/STOP button to resume
printing.
To turn off DPOF mode
To turn off the DPOF mode after
printing, press the DPOF button once
more. The indication “DPOF”
disappears from the display and the
normal indication is shown again.
Changing the number of
duplicates
The number of duplicates for a Print
Mark image that has been set with the
digital camera can be changed on the
DPP-MP1. To do this, perform the
operation described below after step 3
in the section “Bulk printing of images
with Print Mark” (page 15). The unit
must be in DPOF mode (“DPOF”
indication shown on display).
1
Select the Print Mark image
for which you want to make
the change.
Use the SELECT (–/+) buttons to
call up the file number of the
desired image. Then press the
ENTER button. The indication for
the number of duplicates flashes
and can now be changed.
DPOF
2
Change the number of
duplicates.
Use the SELECT (–/+) buttons to
set the number.
3
Press the ENTER button.
The new number of duplicates is
now active.