Qwest SCP-3200 - Manual (Page 33)

Section 2A: Phone Basics 17
Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
ᮣ Press .
Once your phone is on, it may display “Looking for service...,” which
indicates that your phone is searching for a signal. When your phone finds a
signal, it automatically enters standby mode – the phone’s idle state. At this
point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found, your
phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically without
your intervention. You can also initiate a search for service by pressing any
key (when your phone is turned on).
Turning Your Phone Off
To turn your phone off:
ᮣ Press and hold for two seconds until you see the powering down
animation on the display screen.
Your screen remains blank while your phone is off (unless the battery is
charging).
Tip: The Power Save feature helps to conserve your battery power when you
are in an area where there is no signal.
Phone Basics