Quadra-Fire QV32EV-B - Manual (Page 14)

Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05 14
7
Heater Setup
Grate placement holes
Log tabs
Figure 7.3 Install Grate
A. Remove Shipping Materials
• Remove shipping pack from front of fi replace taking care
not to damage grate. See Figure 7.1.
• Remove grate from shipping pack and set aside. Discard
shipping pack.
• Cut and discard the ties bundling the fi rescreen.
• Remove screws holding ember bed shipping tabs in
place.
• Remove the tabs and discard. Replace the screws.
B. Clean Heater
The heater was cleaned at the factory but dust may have
accumulated during shipping.
• Vacuum fi rebox area and wipe acrylic panel (in back of
fi rebox) with a dry, lint-free cloth or paper towel. DO NOT
USE GLASS CLEANER! It will ruin the acrylic panel.
• Remove all fi ngerprints and smudges from front trim to
avoid permanently burning them into fi nish.
C. Accessories
Refer to instructions included with accessory.
D. Install Refractory
Remove protective cover to access fi nal installation items.
Remove Log Assembly
Lift log set straight up and place in safe place.
Install Side Refractory
• Remove the refractory and fasteners from the carton.
• Take the refractory support bracket and bend it until it is
L-shaped.
• Install the bracket to the underside of the fi rebox top using
the screws provided. Keep the bracket loose to allow the
refractory to slide in behind it.
• Tilt the side refractory into the heater and slide it behind
the bracket. See Figure 7.2.
• Tighten the bracket when the refractory is resting on the
hearth and is up against the back acrylic panel.
• Repeat for the other side.
Install Grate
• Place grate legs into corresponding holes in ember bed,
andirons to front. See Figure 7.3.
Reinstall Logs
• Slide log brackets over tabs located on back of ember
bed. See Figure 7.4.
Figure 7.2 Sliding Side Refractory Behind Bracket
(right side shown)
Figure 7.4 Install Logs
Figure 7.1 Shipping Pack