Theta Digital Intrepid - Manual (Page 11)

5
Rear Panel Layout
Figure 3 – Rear Panel Layout showing the optional RS-232 Jacks installed
1. BINDING POST. Connect plus and minus speaker wires for one speaker to appropriately marked terminals of
each post. The binding posts can accept spade lugs, banana plugs or bare wire.
2. SINGLE-ENDED input jack.
3. BALANCED input jack.
4. AC POWER INPUT.
5. Rear panel FUSE. If necessary, replace with same type and rating only.
6. Main Power Switch. Master power switch. Disconnects AC to all circuits. It is recommended that this be left ON
at all times during regular use with the exception of whenever cables are connected/disconnected or when the
unit is not going to be used for an extended period of time.
7. STANDBY REMOTE TRIGGER jack. When the rear panel STANDBY TRIGGER jack receives a 5-12 VDC pulse
the Intrepid will change its mode from either standby to operate, or operate to standby, depending on its current
mode.
8. DB9 RS232 connector. Used for connecting an external controller to the Intrepid to control and monitor its
functions.
9. RJ45 RS232 connector. See DB9 RS232 connector.