Troy-Bilt Two-Stage Snow Thrower - Manual (Page 8)

8
3
Setting Up
Your Snow
Thrower
Figure 8
Figure 7
Drift Cutters (If Equipped)
Drift cutters should be used when operating the snow
thrower in heavy drift conditions.
• On models so equipped, drift cutters are assembled to
the auger housing inverted. See Figure 7.
• Remove the carriage bolts by unthreading the hex
nuts which secure them, and reinstall the drift cutters
facing forward before operating the snow thrower.
Refer to Figure 8.
• Secure to the auger housing with carriage bolts and
hex nuts previously removed. See Figure 9.
If your unit is not equipped with drift cutters, you may
contact Customer Support as instructed on page 2 for
information regarding price and availability.
Snow Thrower Model Drift Cutter Kit:
All models- OEM-390-679
WARNING
Never use your hands
to clean snow and
ice from the chute
assembly or auger
housing.
IMPORTANT
Under any circum-
stance do not exceed
manufacturer’s recom-
mended psi. Equal tire
pressure should be
maintained at all times.
Excessive pressure
when seating beads
may cause tire/rim
assembly to burst
with force sufficient to
cause serious injury.
Refer to sidewall of
tire for recommended
pressure.
Figure 9