Timex Global Trainer W260 - Manual (Page 37)

33
Configure Units Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight UNITS, then press 8 .
3. Press  or q to highlight the setting to change, then press 8 to open the setting change window.
4. Press  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group Adjustment
GLOBAL Select ENGLISH, METRIC, or NAUTICAL. This globally changes all units listed below.
Units for specific measurements can be changed individually, but changing the global
setting overrides all specific changes to individual units mentioned below.
DISTANCE UNITS Select miles to report distance in miles, km to report in kilometers, or nm to report in
nautical miles.
SPEED UNITS Select mph to report speeds in miles per hour, kpm to report in kilometers per hour, or
kn to report in knots.
PACE UNITS Select min/mi to report pace in minutes per mile, min/km to report in minutes per
kilometer, or min/nm to report in minutes per nautical mile.
ALTITUDE UNITS Select ft to report altitude in feet, or m to report in meters.
ASCENT UNITS Select ft/min to report ascent/descent in feet per minute , or m/min to report ascent in
meters per minute.
All measurement data in Performance, Multisport, or Review modes will be expressed using the units you
selected.
Modes
Activate or deactivate Navigate Mode and associated functions, and configure power off behavior.
Configure Mode Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight MODES, then press 8 .
3. Press  or q to highlight the setting to change, then press 8 to open the setting change window.
4. Press  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group Adjustment
NAVIGATE MODE Select ENABLE to make Navigate mode and the Track Back feature available, or select
DISABLE to turn off these features.
POWER OFF
FUNCTION
Select SHOW TIME to display the date and time when the Global Trainer ™ watch is
powered off, or select TURN OFF DISPLAY to make the display blank.
PC Sync Mode
Use PC Sync Mode to make setting changes to the Global Trainer ™ Bodylink ® System watch from your
computer. All Global Trainer ™ watch settings can be changed from the device agent and downloaded to the
watch. You can also upload workout data from the Global Trainer ™ watch to your computer for long-term
tracking, and use this data with your Timex Trainer powered by TrainingPeaks account to optimize your
workout program.