Tapco 6915 - Manual (Page 4)

4
Getting Started
The following steps will
help you set up your
loudspeakers quickly.
1. Make all initial connections with the power
switches OFF on all equipment. Make sure the
master volume, level, or gain controls are all the
way down.
. Connect the line-level outputs from your mixing
console (or other signal source) to the inputs of
your power amplifier.
3. Connect the “Speaker Output” from your
power amplifier (or powered mixer) to the INPUT
connector on the Series 69 (1/4" or Speakon jack).
4. If you are using the 6918s subwoofer with one of
the full-range loudspeakers, connect the 1/4" OUT
or the Speakon LINK EXTENSION to the subwoofer’s
input.
5. Turn on your mixing console (or other signal
source).
6. Turn on the amplifier. Turn up its volume or gain
control(s) as recommended by the manufacturer.
7. Start the signal source, whether it be speaking
into a microphone or starting a CD player. Adjust
the volume controls on the mixer (or other signal
source) for normal operation.
695
• Mackie-designed 2-way full-range loudspeaker
• 1” HF compression driver
• Dual 15” high-precision LF drivers, vented
• Built-in HF driver protection circuitry
• 600 watts continuous power handling
• 8 ohm impedance
• Speakon™ and 1/4” inputs
• Rugged composite vinyl covering
• Protective corner bumpers 6918s
• 18” subwoofer
• 450 watts continuous power handling
• 8 ohm impedance
• Speakon™ and 1/4” inputs
• Durable painted enclosure
• Pole mount socket on top of enclosure