Tunturi Ergometer T6 - Manual (Page 10)

10 ::
TRANSPORT AND STORAGE ::
Please follow these instructions when carrying and moving the cycle
about, because lifting it incorrectly may strain your back or risk other
accidents:
NOTE! Always switch the power off and unplug the power cord before
you start moving the device around!
:: Stand behind the device.
:: Grip the seat with one hand and the handlebar with the other, and
set your foot on the rear support.
:: Tilt the device so that it rests on its transport wheels.
:: Wheel the device to move it, on these transport wheels.
:: Lower the device while holding on to the handlebar and remain
behind the device all the time.
NOTE! If the device is not used for a period of time, the transmission
belt may become temporarily distorted. This can lead to a sensation of
slightly uneven pedalling. However, after a few minutes of use the effect
disappears as the belt returns to its original form.
To prevent the device malfunctioning, store in a dry place with as little
temperature variation as possible and protected from dust.
MAINTENANCE ::
The T4 and T6 require very little maintenance. Check, however, from time-
to-time that all screws and nuts are tight.
:: After exercising, clean the equipment with a soft, absorbent cloth.
Do not use solvents. Sweat may cause corrosion: we recommend
therefore that you protect all metal surfaces outside the plastic
covers with teflon or car wax.
:: Never remove the equipment’s protective casing.
:: The electromagnetic brake forms an extremely powerful magnetic
field that may damage the mechanism of a watch, or the magnetic
identification strip on a credit or cash card, should they come into
immediate contact with the magnets. Never attempt to detach or
remove the electromagnetic brake!