Tripp Lite B004-004 Series - Manual (Page 4)

Installation
Before you begin, make sure that power to all the
devices you will be connecting up have been turned off.
1. Plug the keyboard and mouse into the appropriate
ports on the front of the KVM switch. Connect the
monitor to the Console port located on the back of
the switch.
2. Use the cables in the cable kit (see Hardware
Requirements section) to connect the monitor, key
board and mouse ports of each of the PCs to the
appropriate ports on the back of the switch.
3. Turn on the power to the connected PCs.
Note: The switch’s Power On default links the switch
to the first computer you turn on.
Warning: Do not switch between PCs during boot-
up procedure.
Operation
Manual Port Selection
Press the Port Selection button on the KVM Switch to
switch between computers. The LED lights to indicate
which port is active.
4