TP-Link 54Mbps Wireless Access Point TL-WA501G - Manual (Page 29)

TL-WA501G 54M Wireless Access Point User Guide
5.5 DHCP
Figure 5-17: the DHCP menu
There are three submenus under the DHCP menu (shown in figure 5-17): DHCP
Settings
, DHCP Clients List and Address Reservation. Click any of them, and you will
be able to configure the corresponding function. The detailed explanations for each
submenu are provided below.
5.5.1 DHCP Settings
The System can be set up as a DHCP (Dynamic Host Configuration Protocol) server,
which provides the TCP/IP configuration for all the PCs that are connected to the system
on the LAN. The DHCP Server can be configured on the page (shown in figure 5-18):
Figure 5-18: DHCP Settings
¾ DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you
must have another DHCP server within your network or else you must manually
configure the computer.
¾ Start IP Address - This field specifies the first of the addresses in the IP address
pool. 192.168.1.100 is the default start address.
¾ End IP Address - This field specifies the last of the addresses in the IP address
pool. 192.168.1.199 is the default end address.
¾ Address Lease Time - The Address Lease Time is the amount of time a network
user will be allowed connection to the system with their current dynamic IP Address.
Enter the amount of time, in minutes, the user will be "leased" this dynamic IP
Address. The range of the time is 1 ~ 2880 minutes. The default value is 120
minutes.
¾ Default Gateway - (Optional.) Suggest to input the IP address of the LAN port of
the AP, default value is 192.168.1.1
¾ Default Domain - (Optional.) Input the domain name of your network.
- 24 -