Technicolor - Thomson CS196 - Manual (Page 8)

Getting Started
Using the FM and MW Antennas
Before you use your audio system, you’ll want to
make sure both the FM and MW antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible. The higher the
better.) You’ll also need to connect the MW
antenna loop to the back of the unit if you listen
to MW stations. Rotate the MW loop antenna for
better reception.
Connecting the Speakers
Speaker terminal tabs marked L are for left while
R are for right. Each speaker has a black
(negative) and a red (positive) wire. When
connecting the speakers, match the red wires to
the red jacks and the black wires to the black
jacks.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
Sleep
CD CD CD
TUNE/PRESET
REC USB REC MP3 PLAYER SOURCE
PHONES
BAND/INFO BACK SELECT
DEMO/DIMMER
CD-R / RW COMPATIBLE mp3
ON/ECO
mp3 player
D I G I T A L M U S I C S T U D I O
C S 1 9 6
10 cm
10 cm
Front View
10 cm
10 cm
5 cm
Side View
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Speaker Wire Connection
Push Speaker terminal tab
down to insert wire.
EN
3
CS196 EN 17/2/06 7:28 PM Page 10