Topcom ULTRASONIC 1801 - Manual (Page 5)

5
EN
GLISH
TOPCOM Ultrasonic Humidifier 1801
5 Simple operation
Operation and use of the control panel
1. On/off
• Press the On/Off button (1b) to activate the humidifier. The power LED lights (1a) on. After 10
seconds, the ambient humidity is displayed.
• Press the On/Off button again to stop the humidifier.
2. Humidity control +
• Press this button to increase the humidity setting from 20% to 90%. After flashing for 5 seconds, the
LCD display shows the level of ambient humidity (8).
When the moisture level reaches the pre-set value, the humidifier automatically stops for five
minutes in order to test the humidity in the air.
3. Humidity control -
This function is similar to the "Moisture control +", but it decreases the humidity setting from 90% to 20%.
4. Ionizer
The air ioniser is a device which uses high voltage to ionise, or electrically negative charge, molecules
of air. Negative ions help freshen and purify bad particles in the air, which are causing allergens such as
pollen, mold spores, dust, and animal dander floating in the air . They help to lift mood, alleviate
depression and seasonal affective disorder and promote a sense of well-being.
When the Humidifier is on:
•
Press the Ionizer button to start the ioniser. The ionizer icons (11) blink on the screen.
• Press the Ionizer button again to stop the ioniser.
5. Fog control
• Press the Fog control button to change the generated amount of Fog. The display will indicate the
Fog level (9) (I = Maximum, II = Medium, III = Minimum).
6. Timer
• Press the Timer button to alternatively change the timer from 2 hours, to 4, 8 and 12 hours.
• The time is displayed (10).
When the Timer is elapsed, the humidifier automatically stops.
!!! The humidfier will also stop, when the set Humidity level is reached.
+
-
1 a 7
6
5
4 3
2
1 b
2 4 8 12
8
10 9
11