Therma-Stor Products Group PHOENIX D385 - Manual

 www.usephoenix.com • [email protected] Toll-Free 1-800-533-7533
Owner’s Manual — Phoenix D385
Installation, Operation & Service Instructions
Read and Save These Instructions
The Phoenix D385 provides the perfect combination of
features and performance the restoration industry has been
craving in a desiccant dehumidifier. Designed to operate
vertically or horizontally, the Phoenix D385 provides the
wide operating range and ultra-low grains of a desiccant
with the water removal capacity of the largest LGR’s in
cabinet dimensions identical to our popular Phoenix
200 Max.
The D385 delivers 385 CFM of ultra-low grain process air
and removes an incredible 6 pints per day at AHAM
conditions. The true four hole configuration* allows the
Phoenix D385 to be located in the affected area with the
75 CFM re-activation air stream isolated from the drying
chamber. Three hole designed units** inherently pull
unaffected and/or outside air into the drying chamber. The
D385’s four hole design allows the restoration contractor
to set-up for effective positive, neutral or negative pressure
operation.
Able to operate vertically or horizontally, the D385 will fit
inside most crawlspaces. Having the D385 securely inside,
rather than outside the crawlspace access, deters the possibility of tampering with the dehumidifier or the set-
up. The 385 CFM of process air will provide 3 ACH on an
affected area up to 7000 cubic feet.
The Phoenix D385 is easy to transport and set-up. The
D385 will fit on your truck in the areas already designed
for your LGR’s and will move around the jobsite with the
same portability. All the power to the unit is provided by two
5 volt grounded power cords. Simply plug the cords into
separate 5 amp circuits. Each cord draws only  amps
to power the D385. The re-activation air stream is ducted
through 6” flex duct provided with the unit and stores
conveniently in the top of the unit.
*Having completely separate process and regeneration airstreams.
**Where regeneration airstream is pulled from the process airstream.
The Phoenix D385 Desiccant Dehumidifier
• Ultra low grains
• Wide operating range
• 6 pints per day @ AHAM
• Operates vertically or horizontally
• Process airflow 385 CFM
• Two 23’ power cords:
 Amps per cord
22 Amps
5 Volts/60 Hz
• Unlimited ducting possibilities
• Legendary stainless construction
Phoenix D385
PN
4026700
Specifications subject to change without notice.
TS-387
Revised 7/07
PO Box 8680 • Madison, WI 53708