Targus DVD401 - Manual (Page 7)

7
Targus DVD401 Road Warrior Portable DVD Player Case
3 Put another mounting strap around the upper part of the same front seat.
4 Move the strap to where your shoulders would rest against the seat.
5 Position each straps’ set of swivel clasps toward the center of your car to where the viewing case will
be mounted.
6 Repeat steps 1 -5 to fit the other two mounting straps on the other front seat.
Mounting the viewing case
1 Hold the viewing case between the seats so that the DVD player is facing rearward.
2 Attach the two lower mounting straps’ swivel clasps to the viewing case’s front and rear D-rings
closest to the clasps.
You should have attached four swivel clasps, one to each D-ring.
3 Attach the two upper mounting straps’ swivel clasps to the viewing case’s front and rear D-rings
closest to the clasps.
You should have attached four more swivel clasps, one to each D-ring, for a total of eight.
Connecting mounting straps to D-rings
4 Adjust and tighten each strap so that the DVD player is at the desired viewing angle and the viewing
case is secure.
Storing Your DVD Player in the DVD Player Case
Once inserted in the viewing case, you can store your DVD player in the DVD Player Case when not in
use.
1 Close your DVD player.
2 Unfasten the two elastic snaps.
3 Close and zip the viewing case.
4 Fasten the two elastic snaps to the bottom of the viewing case.
5 Insert the viewing case in the larger pocket of the DVD Player Case and zip the pocket.
The Viewing Case Disk Panel
The viewing case has a fold-away disk panel to hold DVDs. This is in addition to the DVD storage
capacity in the DVD Player Case itself.