TOA Electronics N-CC2360 - Manual (Page 8)

8
7.1. Connection Example
PoE compatible HUB
Software Decorder
10BASE-T/
100BASE-TX
10BASE-T/
100BASE-TX
24V
2 1 24V
1 2 C 1 2 C
10/100M PoE AUDIO
OUT
MONITOR
OUT
OUT IN
CONTACT RDY BUSY ERR
FD/COL LINK
/ACT
AC Mains
1 2 3 4 5 6 7 8 DC-IN
100BASE-TX/1000BASE-T
Network
Color Camera
N-CC2360
N-SD2000
N-VR2010
Network
Video Receiver
BNC plug (optional)
Pin plug
Video output Video input
Audio output Audio input
Monitor output terminal
Note
Connect the output terminal to the monitor
when adjusting the camera.
Contact input/output terminal
Refer to p. 12
24 V AC or 24 V DC
Applicable cables. Solid cable: AWG 26 - 16
Stranded cable: AWG 22 - 16
Monitor
By connecting a network video receiver and PC to a hub and performing each equipment settings at the PC,
camera images can be viewed at the monitor. Installing the supplied software decoder in the PC permits
camera settings to be performed and camera images to be viewed at the pc with the software decoder
installed. When connecting the N-CC2360 network color camera to the hub, use CAT 5 or greater straight
cable fitted with RJ45 connectors.
For each equipment setting, refer to the Setup Manual.
7. CONNECTIONS
Notes
• Do not connect the 24V AC or 24V DC power when using a PoE-compatible hub since the power is supplied
from the hub.
• Connect the 24V AC or 24V DC power when not using a PoE-compatible hub since no power is supplied
from the hub.
• The distance between camera and hub must be shorter than 100 meters using CAT 5 or greater cable.
• Shielded (STP) network cables must be used with this unit to ensure compliance with EMC standards.