Tascam FW1082 - Manual (Page 3)

Control Details
Generally the FW­1082’s surface controls will function as expected, controlling their like
parameters in Sonar. For example: Faders, Mutes, Solos and Transport Control will
control those parameters in Sonar. Exceptions and specific details follow:
Additional Transport Keys
SET + REW = RTZ
SET + FF = Go to Tail
IN locates to the beginning of the selection area
OUT locates to the end of the selection area
SET + IN sets Punch IN point at the current playhead position
SET + OUT sets Punch OUT point at the current playhead position
SET + REC starts automation recording. A parameter must be armed for automation.
SHIFT + SET + IN sets Loop In Point at the current playhead position
SHIFT + SET + OUT sets Loop Out Point at the current playhead position
SHIFT + IN = sets Selection In Point at the current playhead position
SHIFT + OUT = sets Selection Out Point at the current playhead position
<<LOCATE locates to previous marker
LOCATE>> locates to next marker
SET + LOCATE>> = Drop Marker at the current playhead position
Transport Wheel
· Turn the data wheel clockwise to jog forward or counter­clockwise to jog
backward.
· When the SHTL key is off, the data wheel moves the transport in one measure
steps. Holding the SHIFT key reduces this to one­beat steps.
· When the SHTL key is on, the data wheel moves the transport in 1000­tick steps.
Holding the SHIFT key reduces this to 100­tick steps.
Special Keys
SHIFT + PLAY toggles the Audio Engine On/Off
SHIFT + STOP Resets Sonar
SHIFT + any SOLO key will un­solo all tracks.
SELect Keys
Pressing an FW­1082 SELect key alone will select that channel in Sonar. Holding
SHIFT while pressing SELect sets that channel’s fader to Unity in Sonar.
Holding the red REC key while pressing a SELect key will record­enable/disable that
track.