Technicolor - Thomson VP2850F - Manual (Page 17)

16
A D D I T I O N A L
i n f o r m a t i o n s
ShowView
ShowView and the satellite demodulator
If ShowView programming does not operate correctly, it may be because the video recorder
clock is not set correctly.
If the time is correctly set, check and correct if necessary the ShowView numbers assigned to
the various channels.
Press buttons A, 2 ,3 one after the other
to display the menu on the right:
Some television programme guides give the numbers
corresponding to the channels. Follow the screen instructions
to check and change the ShowView numbers.
Some cable or satellite channels share a transmission channel. To
programme ShowView successfully for these channels, each channel has to be set up with a
different Pr number and must also have a different ShowView number.
Refer to the «Manual Channel Setup» chapter of the Getting Started guide to modify the
channel numbers if necessary.
If you programme the recording, using ShowView codes, of a programme broadcast by
satellite, the ShowView programmer can ask you to confirm the channel number (Pr99).
Connection by the aerial cable - During the automatic channel set-up, the video recorder has
assigned channel number 99 to the satellite receiver connected by the aerial socket. Select
this number to view the pictures of the satellite channels. Should these pictures not come up
on the screen, refer to the Set-up manual, chapter “Manual channel set-up”.
Connection by the AUDIO/VIDEO 1 or 2 socket - If your satellite receiver is connected to the
video recorder by the audio video socket, do not choose a number but select the AV1 or AV2
socket.
PROGRAMME SHOWVIEW
Pr 3 155
> Pr 4 123 <
Pr 12 101
REVIEW
ERASE
EXIT E
- + /
0000
ShowView is a trademark applied for by Gemstar Development Corp. ShowView system is
manufactured under license from Gemstar Development Corporation.
U-R6018/48CER/E/SC-BEI/712 25/09/98 12:20 Page 16