Tally Genicom mL450 - Manual (Page 101)

May 04 Publication No. GEG-99197
TallyGenicom mL450 Laser Printer User Manual 4-19
Pushbuttons
System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text “System Menu” is shown on the second line of the
display.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, and Toner
Out.
5. Press the SELECT button to enter a submenu.
6. Use the procedures in the following table to access and change the system settings:
Submenus Default Setting Available Settings Procedure for Changing Setting
Factory Defaults
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults. U.S. U.S.
Non-U.S. 1. Press NEXT or PREVIOUS to toggle
between U.S. and NON-U.S.
2. Press SELECT to choose and set the
factory defaults.
Display Language
This submenu allows you to change
the language of the display
messages. English English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish) 1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set the
language.
Alarm Control
This submenu allows you to set the
alarm control. Single Single
Continuous
Off 1. Press NEXT or PREVIOUS to move
among the alarm settings.
2. Press SELECT to choose and set the
alarm setting.
Power Saver
This submenu allows you to set the
number of minutes the printer is
idle before it reverts to Power
Saver Mode. 15 1 - 999 1. Press NEXT or PREVIOUS to
increase or decrease the number of
minutes.
2. Press SELECT to save this setting.