Trust Computer Products 1290Z - Manual (Page 21)

TRUST 1290Z POWERC@M OPTICAL ZOOM
Message Solution
[Card Protected] Memory card is write-protected, remove the card’s write
protection.
[Open the Lens
Cover] The lens cover is still closed. Open the lens cover.
[No Image] No images on the memory card.
[Rec Error] Problems have arisen with saving the image. Switch on
the camera again.
[Card Error] The camera cannot format the memory card. Use a
card reader, or try another memory card.
Table 10: messages shown on the LCD display
17
U K
Problem Cause Possible solution
Press the power button to
switch on the camera.
The batteries are
discharged. Replace the
batteries with new ones.
Refer to the section on
batteries.
The camera has
no power. The camera is switched off.
The batteries are inserted
incorrectly. Check the
battery orientation. Refer to
the section on batteries.
Memory card full? Backup your images and
delete unwanted images, or
format the memory card. The camera won’t
take a picture.
Is the camera connected to
a computer? The camera’s buttons are
not operational whilst
connected to a computer.
Disconnect the camera to
take photos.
Is the flash switched on? Check whether the flash is
set to automatic, or to
always on. Refer to the
section on the flash. The flash doesn’t
work.
The batteries may be weak. The flash cannot be charged
if the batteries are almost
empty. Switch off the
camera, and wait a few
seconds before switching it
on again. If this doesn’t
solve the problem then
replace the batteries.
Hold the camera still;
if so required, use a tripod.
The camera or subject was
moving when the shot was
taken.
Use the self-timer.
The images are
blurry.
Adjustment of the lens focus Check that the lens is
focused correctly.
Messages shown on the LCD display, and solutions