Tascam CD-RW2000 - Manual (Page 13)

2 – Features of the CD-RW2000—Remote control unit
TASCAM CD-RW2000
13
2.3 Remote control unit
1
OPEN/CLOSE key
Opens and closes the disc tray (equivalent to
3
).
2
Number keys (0 through 10 and +10)
Use these keys for direct entry of track numbers
when playing back, or making a programmed play
list.
3
CLEAR key
Use this key to clear a mistaken entry made with the
number keys.
4
REPEAT key
Use this key to change between the various repeat
modes when playing back (see 3.3, “Repeat play”).
5
DISPLAY key
Use this key to switch between the different display
modes available (equivalent to
A
).
6
MENU key
Repeated presses of this key cycle through the differ-
ent menu items used to set parameters (equivalent to
9
).
7
ENTER key
Pressing this key is equivalent to pressing the MULTI
DIAL control
B
to confirm an entry.
8
FADER key
Use this key to start fade-in recordings or to start a
fade-out when recording (equivalent to
5
).
9
MONITOR key
Use this key to output the signals received at the cur-
rently selected input(s) through the outputs when not
recording or in record ready mode.
A
PLAY MODE key
Use this key to choose between the different play-
back modes (single play, continue play, etc.).
B
FINALIZE key
Use this key to finalize recordable discs. See 1.2,
“Finalizing” and 5.1, “Finalizing” for details (equiva-
lent to
E
).
C
ERASE key
Use this key (with CD-RW discs only) to erase
tracks, or a whole disc, or to refresh a “bad” disc, or
to unfinalize a finalized disc. See 5.2, “Erasing” for
details (equivalent to
F
).
D
RECORD key
Use this key to enter record ready mode (equivalent
to
J
).
E
SYNC REC key
Use this key to turn synchronized recording on and
off (equivalent to
K
). See 4.3.1, “Synchronized
recording” for details).
F
REC MUTE key
Use this key when recording, to mute the input signal
for about four seconds and then to enter record ready
mode (see 4.3.4, “Rec mute function”).
G
SEARCH keys
Use these keys to move the playback position inside
a track.
H
SKIP keys
Use these keys to move between tracks when playing
back (equivalent to turning
B
). They are also used to
set the parameter values, etc.
I
STOP key
Use this key to stop playback or recording (equiva-
lent to
G
).
J
PAUSE key
Use this key to pause playback or recording (equiva-
lent to
I
).
K
CALL key
Used to start playback from the last pause position
before playback starts (equivalent to
L
).
L
PLAY key
Use this key to start playback, or enter record mode
from record ready mode (equivalent to
H
).
2.4 Connections
The following should be noted when you connect the
unit to other equipment.
NOTE
Do not connect or disconnect audio or other equipment to
or from the CD-RW2000 while power is supplied to the
units. Always turn off the power when connecting or dis-
connecting units.
It is possible to connect the unit’s DIGITAL AES/EBU
IN
W
, DIGITAL COAXIAL IN
X
and DIGITAL
OPTICAL IN
Y
to other equipment at the same time.
However, the unit can receive signals from only one
digital input at a time.