Topcom BABYTALKER 2500 - Manual (Page 4)

4 Topcom Babytalker 2500
Topcom Babytalker 2500
3.2 Baby unit (Illustrations C and D)
4 Getting started
4.1 Baby unit battery Installation
The baby unit can be used either with 3 AA - Size batteries (alkaline batteries recommended)
or the household AC current. The baby unit has no charging function!
It is recommended to add the batteries. It will automatic backup when there is a main power
interruption.
1. Turn the screw 90° of the battery cover (27) on the backside of the baby unit in a counter
clockwise direction using a screw driver. Remove the battery cover (28). Do not try to
rotate the screw further than the position ‘open’.
2. Install 3 AA alkaline batteries following the polarity as shown.
3. Close the battery compartment.
4. Press
(17). The power LED (19) will illuminate.
5. Press and hold (17) to switch off the baby unit.
When the battery level is low, the power LED (19) will blink.
Do not mix old batteries with new ones.
Keep batteries away from small children
Do not short-circuit & dispose of in fire.
Remove the batteries if this device is not going to be used for a long period.
16. Night Light button
17. On/Off button
18. Paging button
19. Power LED
20. Play button
21. Melody button
22. Microphone 23. Volume down button
24. Volume up button
25. Night Light
26. Hang handle
27. Battery cover screw
28. Battery cover
29. Power adapter connector
+
+
+
+
-
A A x 1
+ -
A A x 1
+ - A A x 1
90° MAX