Taylor AB-1002-BL - Manual (Page 7)

7
USING YOUR MULTI CHOPPER & BLENDER SYSTEM
BEFORE FIRST USE
•
Make sure the voltage in your outlet is the same as the voltage indicated on
the appliance. This product is for 120 –Volt AC electrical outlet only.
• The Multi Chopper & Blender System is equipped with a safety locking sys-
tem to increase security during operation. The unit will not work if the jar
and collar / blending jar / travel jar and collar are not properly locked in
place.
• Remove any bags, labels or stickers from the appliance.
• Clean the base with a damp soft cloth.
• Wash all of the removable parts – jar and collar, storage lid, blending jar and
lid, travel jar and collar and travel lid using a sponge, warm water and mild
dish detergent. Rinse and dry carefully. Use caution when washing compo-
nents with blades as the blades are very sharp. Do not allow your hand to
come into contact with blade edges.
• NOTE: do not immerse the base unit in water when cleaning.
HOW TO USE THE CHOPPER
• Place the unit on a flat, sturdy surface.This appliance is not for use in convec-
tion or conventional ovens, microwaves, or on a stovetop.
• Make sure the appliance is switched off and unplugged.
• Wash and dry all components thoroughly as stated above.
• Clean and wash the food to be used.
• Add food ingredients to the jar, distributing them evenly with a spatula (not
included). When chopping larger foods, pre-cut them into pieces of an even
size, approximately ½ inch to ¾ inch pieces.
• Screw the collar onto the jar. Take the jar with collar and attach to the base
unit. Always be sure that the appliance is properly assembled before using.
Blades are extremely sharp; never touch the cutting edge of blades.
• Plug the appliance into the power outlet.
• Start the chopper by pushing the pulse button continuously until the food is
sufficiently chopped.
• Unplug the unit and reverse the above procedure to disassemble.