Tripp Lite SRCABLETRAY - Manual (Page 3)

3
3 – SRCABLETRAY Installation
Note: You can remove the roof panel to aid installation, but this step is not required.
Assemble the cable tray by attaching the support sections
A
to
the trough section
B
with the included screws. Note: The support
sections should be attached inside the fl anges of the trough
section, not outside.
Insert the tabs
C
at one side of the cable tray into the matching
roof panel slots
D
. (Several sets of slots are compatible, allowing
you to adjust the cable tray’s position to match your preference.)
Compress the unattached cable tray support section
A
until you
can insert the remaining tabs
E
into the matching roof panel
slots
F
. When you release pressure from the cable tray support
sections, they will expand to provide a secure fi t.
Use the included hex nut
G
and lock washers
H
to connect one
end of the included ground cable
I
to a grounding post
J
at
the corner of the cable tray. Connect the other end of the ground
cable to the metal frame of the rack enclosure. (Follow the ground
wires connected to the rack enclosure’s doors to locate several
convenient ground connection points on the frame.)
1
1
2
3 4
A
C
C
D
D A
B
E
E
F
F
G
J
I
4 – SRCABLETRAYEXP Installation
Note: You must install SRCABLETRAY before installing SRCABLETRAYEXP. SRCABLETRAYEXP includes two expansion sections; you may
install one or both, depending on your needs.
4-1 One Expansion Section
Attach the expansion section
A
to the cable tray
B
with the
included screws.
1
1
A
B
3 4
2
H
H
TO