Tannoy CMS801 PI - Manual (Page 3)

CMS 801 Manual 21-6-07AW 28/9/07 10:03 Page 3
Composite
C M Y CM MY CY CMY K
4 5
4. PRODUCT FEATURE IDENTIFICATION:
Note that the CMS801 PI model’s transformer is pre-attached to the CMS801 PI back can for easy install.
Fig 1.1: The blind-mount (BM) models come with a pre-fitted back can
Fig 1.2: A pre-install (PI) model shown without optional pre-install back can
Fig 1.3: Optional pre-install (PI) back can for PI models
Conduit/Cable Clamp
Euro Type Connector
Mounting Wings
Tuning Port
Rotary Switch
Screws for
mounting wings
Screws for
mounting wings
Rotary Switch
Tuning Port Euro Type Connector
Conduit Knock-out points
Euro Type Plug Euro Type Connector
5. ACCESSORIES:
Each product is supplied with the following accessories as standard:
C-Ring Tile bridge kit
Note: A tile bridge kit
must always be used
when installing into
suspended ceiling tiles
Grille Cut-out template
Paint Mask
CMS
Optional accessories:
Plaster (Mud)
Ring 60W Transformer
NOTE: for use with CMS801 PI
model in distributed lines without
back-cans.